КНР Провинция Хэбэй,Город Шицзячжуан,Уезд Чжэндин,Северная улица Яньчжао 312
тел:+86 311 85174190
Факс:+86 311 85174239
электронная почта:xmf@xmftools.com |
|
|
| Q: |
Blade worn out of round (Causes / Remedies |
| A: |
1,Incorrect mounting of blade / remount blade correctly.
2, Worn bearings, spindle or blade arbor / replace worn bearing, realign blade shaft or replace worn blade arbor.
3,Blade too hard for material being cut / use proper blade specification for material being cut. |
| Q: |
Segment loss (Causes / Remedies) |
| A: |
1,Blade too hard for material being cut / use proper blade specification for material being cut.
2,Overheating due to lack of water / check water feed system and make sure the water flow is adequate on both sides of blades.
3,Blade twisting or jamming in cut / keep sawing straight when the blade working (concave blade exceptional)
4,Out of round blade / replace worn bearing, realign blade shaft or replace worn blade arbor.
5, Incorrect blade tension / ensure blade is running at correct RPM.
6,Excessive cutting speed / slow down the cutting speed .
7, Undercutting of steel center / use sufficient water to flush out the cut or choose blade with protective teeth. |
|
